Нанесення / видалення

Немає жодного товару в цієй категорії.

Нанесение
Удаление

Spraying Fluid Film

The most effective way to apply Fluid Film in its bulk form is with...

Нанесение
Удаление

Spraying Fluid Film

The most effective way to apply Fluid Film in its bulk form is with the use of standard airless paint spraying equipment. Airless paint sprayers operate under high pressure, usually between 1500 - 3500 PSI, which atomize paint into tiny droplets, propelling them towards the desired equipment.

Fluid Film impregnates the pores of exposed metal, where it leaves a lasting, active barrier that moisture and oxygen cannot penetrate.

We recommend a minimum of around 2000 PSI. Applied at a film thickness of 3 - 4 mil, this will cover approximately 250 sq. ft. per gallon. Fluid Film is thixotropic and gets heavier upon sitting. This does not affect the quality of the product. Stir or shake well to return the product to a thinner viscosity.

Fluid Film protects all metals, and will not harm electrical connections, most paints or plastics. Caution should be used around non oil -resistant rubber goods: May cause swelling. It provides powerful protection for equipment in shipment, in storage and in use.

We recommend a spray tip of between 515 -517 for best atomization. To understand tip sizes, the 3 numbers represent the fan size and size of the orifice. The first number represents the fan size. For instance, for a 515 the fan size would be 10 inches wide, if measured one foot from the area being sprayed. That first number (5), represents 1/2 of the fan width (10). The last 2 numbers refer to the size of the orifice. Represented in thousandths of an inch, for a 515 the last two numbers would represent .015. The larger those numbers, the more paint that will be applied.

Removing Fluid Film

For easy removal of Fluid Film for the purpose of handling or inspection, a high pressure, cold-water pressure wash (1,000 - 3,000psi) is recommended. A standard, industrial strength pressure washer will suffice.

Fluid Film can also be removed by warm water detergent wash or with a commercial-grade biodegradable cleaner. When choosing a cleaner, one formulated to remove tough grease and grime deposits is advised.

Fluid Film can also be rubbed in like a wax if total removal of the product is not necessary, since Fluid Film is safe for use on most paints and plastics. This will also offer extended protection of materials.

For equipment that is to be painted following a treatment of Fluid Film, a more vigorous cleaning is advised. A high-pressure, hot water or steam detergent wash (minimum 120F) is needed. Utilizing cleaning compounds specifically formulated to remove grease/wax as a pre-treatment process for painting are highly recommended.

Більше

Контакти

Цілодобова гаряча лінія

Тел.:0123-456-789

Зв'яжіться по гарячій лінії

Розсилка

Мапа сайту

Контакти

Кошик

товар (порожньо)

Немає товарів

0,00 ₴ Доставка
0,00 ₴ Всього

Кошик Оформити